Cards, Holidays 2022, St. Patrick's Day, Watercolor

Easy Rainbow Watercolor Background Square Card

St. Patrick’s Day Cards

Hello friends. Need a quick card for St. Patrick’s Day?!? The watercolor background on this card is super quick to make and there’s no for perfection (which I love) necessary because it should look like paint was dropped on the paper.

For this card, I cut a piece of Neenah 110lb Classic Crest Cardstock 8.5 X 11″ to 4-1/4 x 8-1/2″ and scored at 4-1/4″ to create the card base. Then, using the largest of the scallop squares (4 x 4″) from the Sizzix Framelits Die Set 6/PK – Squares, Scallop, I diecut the card base. I left the die about an 1/8″ off the card so that it would leave the top connected.

I cut a piece of Montval Acid-Free Cold Press Watercolor Paper, 140 lb, 18 X 24 in, Natural White to about 4 x 4″ and used the Catherine Pooler ink refills in Party Dress, Tiki Torch, Limoncello, Lime Rickey, Something Borrowed, and Grape Crush to create drips on the panel. I just squirted a dot of the ink onto the very top of the panel then using a brush dripped water onto it and let it run down the page. I added some splashes with a few of the same inks.

Then I diecut the panel using the second largest die from the Sizzix s Die Set 6/PK – Squares, Scallop (3-3/8 x 3-3/8″). I stamped the cat from Newton’s Nook Designs Newton’s Pot of Gold and the shamrocks from Simon Says Stamps WOOLY-LUCKY stampset onto some Neenah 110lb Classic Crest Cardstock 8.5 X 11″ with Memento Tuxedo Black Ink.

I colored the images with Copic colors. I used N5 & N8 and Y15 & Y17 for the pot of gold; YG17, G07 & G09, N5 & N8 and Y15 & Y17 for Newton’s hat; N1, N2, 0 & R20 for Newton; and YG17, G07 & G09 for the shamrocks.

I stamped the sentiment from the from Newton’s Nook Designs Newton’s Pot of Gold onto some Neenah 110lb Classic Crest Cardstock 8.5 X 11″ with Memento Tuxedo Black Ink, then using my MISTI stamped over it with Versamark Ink, heat embossed it with Ranger CLEAR Embossing Powder and cut it to 3/8 x 2-1/2″.

I adhered all the images and sentiment onto the panel and to the card base using 3M Foam Tape.

I left the inside of the card blank.

Dimensions


Supplies

Thanks for reading this post. I hope you enjoyed and I’ve inspired you to give this card a try for yourself. Leave comments or questions below or feel free to email.